NL8110 & NL8111 are heavy duty urethane lined hoses that are recommended for suction, discharge, and pneumatic transfer of wet or dry abrasive materials such as sand, grain, wood chips, metal chips, stones, rock dust, and fly ash as well as various chemicals, waste, or water solutions (when used for wet materials spiral clamps must be used for proper sealing). They also can be used on municipal vacuum trucks for storm drain clean out. These hoses offer an in-between option to the lighter duty NL8105/NL8106 Series and the heavier duty, less flexible traditional "rubber" material handling hoses like our NL8155 Tan, NL8160 Hydro Excavation, or NL8200 Material Handling. NL8110/NL8111 have a smooth, urethane tube that is very durable and abrasion resistant. They will also remain flexible in very cold temperatures and their covers are manufactured with anti-static compounds. NL8111 delivers quality and economy, it offers a lower price point alternative to higher end, brand name products and is designed to compete with lower cost alternatives being introduced to the market. *Service life of material handling hoses may vary depending on the operating conditions, hours of use, and the product being conveyed. Always rotate the hose regularly for even wear and inspect the tube for degradation before use.

Construction: Tube: Smooth, clear polyurethane, static-dissipating (conductive). Cover: Corrugated, blue (NL8110 & NL8111) or black (NL8120) PVC blend. Reinforcement: Rigid, left hand (NL8110 & NL8120) or right hand (NL8111) PVC helix.

Typical Fittings: Insert type fittings can wear out prematurely with highly abrasive products; N676 left hand spiral or N51 double bolt clamps. Note: Spiral clamps or strapping must be used for proper sealing with wet materials.

Temperature Range: -40°C (-40°F) to +65°C (149°F)

Detail Comments: Service life of material handling hoses may vary depending on the operating conditions, hours of use, and the product being conveyed. Always rotate the hose regularly for even wear and inspect the tube for degradation before use. Continuous flexing of a hose within 18 inches of a fitting is a common cause of hose failure. We recommend installing a 12 to 16 inch section of Banding Coil to the hose end that is over flexing.

Cut Method: Sawzall / Hacksaw or Safety Scissors - Wear Safety Gloves