These are PTFE bored hoses with a 304 stainless steel cover which also acts as the reinforcement. They can be used in short lengths for a variety of fluid, hydraulic, air compressor, or gas applications where temperature, purity, or corrosion resistance are of prime concern, such as on short, low pressure steam lines (not for steam/cold water cycling), food grade beverage transfer lines (meets FDA 21 CFR 177.1550), chemical lines, or for truck/bus air compressor discharge. Our NL530 PTFE with a black static conductive liner should be used where static build up is a concern, as well as with with fuels, flammables, and steam. Since the reinforcement is exposed and also acts as a cover, it is NOT designed for abusive or rugged environments - nor is it designed for long continuous pipe-runs or radiant heating systems. Due to the rigid nature of PTFE tubing, special attention must be taken to prevent this hose from kinking or exceeding its bend radius (for additional bending capabilities refer to our NL535 Series Convoluted Hose). Our standard NL525 SAE100R14 has a white PTFE tube; for applications where static electricity is a problem, please use our NL530 SAE100R14 static conductive with a black PTFE tube. For chemical applications, always refer to a chemical resistance charts and drain after use. Where there are risks of asphyxiation, hose should be installed in well vented areas.

Construction: Tube: Black extruded 0.030" smooth bore PTFE. Cover and Reinforcement: One braid of high tensile 304SS steel wire.

Typical Fittings: NL525/530 Hose - N526xx brass permanent crimp, N525xx brass reusables, N527xx stainless permanent crimp, N528xx/N529xx 2-piece permanent crimp. NL535 Hose - N537xx stainless permanent crimp, N538xx 2-piece permanent crimp, Aeroquip OTC Crimp fittings. For corrosive applications, we can also supply "PTFE encapsulated" stainless ends (for wetted surfaces).

Temperature Range: Continuous: -54°C (-65°F) to +232°C (450°F). Steam only: to +200°C (388°F)

Warning: Critical Application-Follow Coupling/Maintenance Procedures

Cut Method: Bench Mount Electric Saw // Wear Ear & Eye Protection