Our NL8210 Allcrete hose is meant to last and has proven itself as an industry leader - offering greater durability, quality, and lower overall replacement costs. It is used to convey wet cement, plaster, grout, wet shotcrete, and concrete to building structures, dams, tunnel faces, swimming pools, or construction sites. It can also be used for material handling on drilling rigs. This is a rugged, durable, high performance hose that is to be coupled with high-quality, abrasion resistant permanent swage, heat treated couplings. *Service life of material handling hoses may vary depending on the operating conditions, hours of use, and the product being conveyed. Always rotate the hose regularly for even wear and inspect the tube for degradation before use. Concrete hose is typically not repaired as the wall/tube will wear down during service, and therefore the coupling integrity is significantly compromised if re-installing an end.

Construction: Tube: Smooth, black Chemituf rubber. Cover: Wrapped, smooth, black SBR rubber. Reinforcement: Multiple spiral plies of high strength fabric.

Typical Fittings: WFT- Heat treated swaged ends (HD flanged ends, DO NOT use Grooved or NPT ends for 'Concrete Pump' service). For 1"-1-1/2" Grout Lines, N95- Internal Expansion Ends and NH42-xxxSS / NH45-xxxSS HD Camlocks may be used. Whipcheck Safety Cables & Nylon Slings (must be properly installed in an extended position).

Temperature Range: -35°C (-31°F) to +80°C (176°F)

Detail Comments: *Working pressures shown based on this hose being used to transfer concrete, not for water or other fluids. Pressure rating of hose assemblies will also depend on choice of fittings. For non-concrete applications the working pressure will vary depending on the safety factor required (as an example for water, certain sizes could be rated to 500-600 psi).

Warning: Critical Application-Follow Coupling/Maintenance Procedures

Cut Method: Sawzall / Hacksaw or Safety Scissors - Wear Safety Gloves